Troubleshoot

Symptoms of Bad Glow Plugs

White Chevrolet Silverado 2500 HD diesel pickup on a ramp in a workshop, seen from a low angle across a polished floor

A diesel that starts fine all summer suddenly cranks and cranks on the first cold mornings of the year, then fires up, shakes, and blows a cloud of white smoke before settling down. By lunchtime it starts instantly. That pattern, worse the colder it gets and fine once the engine is warm, is the classic sign of failing glow plugs.

Glow plugs are small electric heaters that help a cold diesel start. When one or more of them fails, the engine still runs, but cold starts get harder and messier. This guide covers what glow plugs do, the symptoms of bad ones, how to tell them apart from gelled fuel or a weak battery, how to test them, and what replacement typically costs.

The common symptoms at a glance:

SymptomWhat You NoticeHow Urgent
Hard starting in the coldLong cranking before the engine catches, worse the colder it isModerate; can leave you stranded in a cold snap
No start in very cold weatherCranks normally but will not fireHigh in winter
Rough idle after a cold startShaking and misfiring for the first minute or twoModerate
White smoke on cold startThick white or grey smoke that clears as the engine warmsModerate
Glow plug or check engine lightCoil-shaped light flashing or staying on, or a stored codeModerate; get the code read
Loud knocking when coldHarsh diesel clatter at start-up that fades with warmthLow to moderate

Stop cranking after 10 to 15 seconds and wait before trying again. Long cranking drains a cold battery and overheats the starter. Never spray starting fluid (ether) into the intake of a diesel with glow plugs or an intake heater, because the hot elements can ignite it early and cause serious engine damage. If the engine cranks but will not start after a very cold night, rule out gelled fuel before replacing glow plugs.

What Glow Plugs Do

A diesel has no spark plugs. As the U.S. Department of Energy’s Alternative Fuels Data Center explains, diesel fuel is injected into the combustion chamber of the engine and ignited by the high temperatures achieved when the gas is compressed by the engine piston. That works perfectly once the engine is warm. On a cold morning, though, the cold cylinder walls and cold intake air soak heat out of the compressed air, and it may not get hot enough to light the fuel reliably.

Glow plugs solve that. Each cylinder has a pencil-shaped heater with its tip in or near the combustion chamber. When you turn the key, the glow plug control module or relay powers them for a few seconds, and the glow plug light on the dashboard stays on until they are hot. That is the pre-glow, and it is why older diesels told you to “wait to start”. Most modern systems also keep the plugs powered for a while after the engine starts, called post-glow, to smooth out the idle and reduce smoke until the engine warms up.

Glow plugs wear out like any heater element. They typically last a long time, often 100,000 miles or more, but they fail sooner with short trips, a faulty controller that overpowers them, or injector problems that overheat the tips.

Symptoms of Bad Glow Plugs

1. Hard starting in cold weather

The most common sign. The engine cranks for much longer than usual before it catches, and the colder the morning, the worse it gets. Bosch lists a vehicle that starts only after excessive cranking among the signs that glow plugs need replacing. Because each plug serves one cylinder, one or two dead plugs make starting harder; most or all of them failing can stop a cold start completely.

2. The engine will not start at all in the cold

With several plugs failed, or the controller or relay dead so that none of them heat, a diesel may simply refuse to start below a certain temperature while starting normally in mild weather or once it has been warmed up. That temperature dependence is the giveaway.

3. Rough idle and misfiring after a cold start

A cylinder whose glow plug is not working stays cold and misfires until the engine warms it. You feel it as shaking, an uneven idle and sometimes a hesitation when pulling away, all of which smooth out after a minute or two. Bosch also lists a vehicle that idles roughly after initial start-up.

4. White smoke from the exhaust on cold starts

When a cold cylinder does not burn its fuel completely, the unburned diesel leaves the tailpipe as white or grey smoke with a raw fuel smell. It clears as the engine warms. White smoke that continues after the engine is fully warm points elsewhere, such as injectors, timing or coolant getting into the cylinders, so it is worth noting when the smoke stops.

5. Glow plug light or check engine light

Most diesels monitor the glow plug circuit. A glow plug indicator that flashes while driving, or stays on far longer than usual, signals a fault in the system, and the engine computer usually stores a code. Generic codes in the P0380 and P0670 to P0684 range relate to the glow plug circuits and control module, with P0671 to P0678 identifying a specific cylinder’s glow plug circuit. Manufacturers also use their own codes, so read the exact code and description with a scan tool.

6. Harsh knocking when cold

All diesels clatter more when cold, but a cylinder that is misfiring or igniting late because its glow plug has failed makes the knock noticeably harsher until the engine warms up.

Is It the Glow Plugs, the Fuel or the Battery?

Several winter problems produce the same hard start, so check these before buying parts:

  • A slow crank points to the battery, not the glow plugs. Glow plugs draw a lot of current, so a weak battery struggles to power them and the starter at the same time. Test the battery first. Our guide to how long a car battery lasts covers the warning signs.
  • Gelled fuel causes a no-start or a start-then-stall after a very cold night, often with waxy, cloudy fuel in the filter. Glow plugs cause hard starting that improves as soon as the engine catches. Our guide to diesel fuel gelling covers the temperatures involved.
  • Water in the fuel can freeze in the filter or separator. A water-in-fuel warning light is the clue. See our guide to a frozen fuel line.
  • Smoke after the engine is warm is not a glow plug problem. Black smoke points to fueling or a restricted air supply, and on newer diesels a clogged diesel particulate filter brings its own warning lights and power loss.
  • A no-start in any weather is more likely a fuel delivery, sensor or starting problem. Our guide to why a car cranks but will not start covers the broader list, and our guide to why a car will not start in cold weather covers cold-specific causes.

How to Test Glow Plugs

  1. Read the codes. A scan tool often points straight to the cylinder or the control circuit.
  2. Check the glow plug fuse, relay or controller. If no plugs are getting power, the fault is upstream of them. With the key on and the glow plug light lit, there should be battery voltage at the plug terminals or the feed wire. No voltage means a fuse, relay, controller or wiring fault.
  3. Measure each plug’s resistance. Disconnect the wire from each plug and measure from the terminal to engine ground with a multimeter. A good plug usually reads a low resistance, often around 0.5 to 2 ohms depending on the design, so check the specification for your engine. An open circuit, shown as no reading or infinite resistance, means a burned-out plug.
  4. Check current draw. A clamp-on ammeter around the feed wire while the plugs are powered shows whether each plug is drawing current. One that draws nothing is dead.
  5. Inspect removed plugs. A swollen, cracked or burned-away tip is a failed plug. If several tips are damaged the same way, have the injectors checked, because a dripping injector can overheat glow plug tips.

Testing at the plug terminals is straightforward on many engines and can be buried under the intake on others. Removing the plugs is a separate and riskier job, covered below.

Replacing Glow Plugs: The Snapping Risk

Glow plugs sit in the cylinder head for years, and carbon and corrosion can seize them in their threads. On some engines they are notorious for snapping when removed, and a broken plug means drilling out the remains, sometimes with the cylinder head removed, which turns a cheap job into an expensive one. To reduce the risk, work on a warm engine, use penetrating oil, use the correct thin-walled socket, apply steady force rather than jerking it, and stop if a plug will not turn. Install new plugs with the specified torque, because overtightening can damage the plug or the head.

Many owners replace all the plugs at once. If one has failed from age, the others are usually close behind, and the labor to reach them is the same.

What Glow Plug Replacement Costs

RepairTypical Cost
Glow plug (each)$15 to $60 for the part
Full set replaced at a shop (4 to 8 plugs)$250 to $1,000, depending on access
Glow plug relay or control module$100 to $400 installed
Extracting a snapped glow plug$300 to $2,000 or more

The spread is mostly labor. On some engines the plugs are easy to reach from the top; on others the intake manifold or other components have to come off first.

Can You Keep Driving With Bad Glow Plugs?

Yes, in most cases. Once a diesel is running and warm, the glow plugs play no part, so a car with a failed plug drives normally after the first few minutes. In mild weather you may not notice the problem at all.

The risks build up over time and with the cold. Repeated hard starts wear the starter and battery, and a car that will not start in a cold snap can leave you stranded. Cold misfires leave unburned fuel in the cylinder, which can dilute the oil. In rare cases a badly degraded plug tip can break off into the cylinder, which can damage the piston and valves. If you live somewhere cold, replace failing glow plugs before winter sets in, and consider an engine block heater, which makes every cold diesel start easier.

Glow Plug Questions Answered

What are the first signs of bad glow plugs?

Longer cranking before the engine starts on cold mornings is usually the first sign, often with a rough idle and white smoke for the first minute or two. The problems fade as the engine warms and may disappear entirely in mild weather.

Can a diesel start with bad glow plugs?

Often, yes, especially in mild weather or if only one or two plugs have failed. In very cold weather, several failed plugs or a dead glow plug controller can stop the engine starting at all.

How do I test glow plugs?

Read any stored codes, confirm the plugs are getting battery voltage when the glow plug light is on, then measure each plug’s resistance to ground with a multimeter. A good plug reads a low resistance, typically around 0.5 to 2 ohms; an open circuit means it has burned out.

How long do glow plugs last?

Often 100,000 miles or more, but it varies widely with the engine, the plug design and how the vehicle is used. Frequent short trips, a faulty controller and dripping injectors all shorten their life.

Should I replace all glow plugs at once?

It is usually worth it. If one has failed from age, the others are likely close, and the labor to reach them is the same. Replacing them all at once avoids paying for the same access again later.

Is it bad glow plugs or gelled diesel?

Glow plug problems make the engine slow to start but it then runs, roughly at first. Gelled fuel usually causes a no-start or a start followed by stalling after a very cold night, often with cloudy or waxy fuel. Both are worse in the cold, so check the fuel filter and the glow plug circuit.

As an Amazon Associate we earn from qualifying purchases.

About the author

The Motor Guy

The Motor Guy is a passionate car enthusiast with a love for troubleshooting and diagnosing all sorts of vehicle problems.

With years of experience in OBD diagnostics, he has become an expert in identifying and solving complex automotive issues.

Through TheMotorGuy.com, he shares his knowledge and expertise with others, providing valuable insights and tips on how to keep your vehicle running smoothly.

Qualifications:
- 12 years experience in the automotive industry
- ASE Master Automobile Technician
- A Series: Automobile and Light Truck Certification, A9 Light Vehicle Diesel Engine Certification
- Bachelor's Degree in Information Systems